Dixon® Ground Joint Washer Seal Spud, Series: Boss™, Fitting/Connector Type: Spud, 3/4 in Nominal Size, Thread Wing Nut x MNPT, 1-7/8 in A/F Hex, Steel, Plated, 2-3/16 in L, Domestic
Features
- The spud part of the coupling serves as one half of the connection and is usually fixed to the equipment
- The stem part that is clamped to the hose is the other half
- The two halves are connected or disconnected by rotating the wing nut on the spud, when connected they achieve both a mechanical and a pressure seal
- Easy to seal
- Boss couplings supply a convenient threaded fitting to connect two lengths of hose, or a single length to a male or female threaded outlet
- Use with boss washer seal fittings
- A Klingersil C-4401 washer is inserted between the stem and spud
- Recommended for steam service up to 450° F
- Worn-out hose couplings can be dangerous
- They should be checked regularly and replace when necessary
- Each coupling user should review applications and add safety devices where indicated
- Note: pressurized steam is an extremely dangerous commodity
- Only hose, fittings, clamps and accessory items that have been approved for steam service should ever be used! never use an unapproved item for steam service
- Always follow the manufacturer's product recommendations for pressurized steam handling
- Warning: this product contains a chemical known to the state of California to cause birth defects or other reproductive harm
- Do not use in connection with drinking water
- Wash hands after handling